Above both buttons add a Display List showing which user is logged in. Close Add a Login Button call it 'Login User'.

Next create an Account called Operator and put a 'Y' only in the box for the letter A. Next create an account called Calibration and do the same. Create an account called Engineer and select 'Y' for all of the Letters A through P. Go to the Explorer in Studio on the left and go to User Accounts. Thanks in advance.I have RSView Studio 4.0 I idon't know what you are using, but here you go.

If anyone out there has any ideas or experience with this I would appreciate hearing from you. I have done everything I know to fix this problem, delete, recreate, uninstall the software, the data base and all to no avail. When I write to this, lets say the value of 2, the number that written to the recipe is 2.45655e40. It is formatted in the numeric input object properties as 3 digits to the left and 0 digits to the right of the decimal point. I have a recipe input for the number of holes to drill, which writes from the numeric input object to the recipe for number of holes. However it has been converting the data entries for some cells in the recipe database to scientific notation and ignoring the format. All the items in the numeric input object properties are correct. All the formatting is correct, all the addressing is correct. Now have a problem with the recipe data base. I have had the equipment at the customer site up and running for 4 months now with no problem. Hello, I am using a Weintek EMT3105P HMI with a 1769-ERM元3 AB Compactlogix PLC. If a continuity exists,Ĭheck for wire fibers between terminal or send drive in for repair. Remove all power and motor connections and preform a continuity check form the DC bus to the U, V, and W motor outputs. Reduces acceleration rates.The Kinetix 300 drive has a short circuit overcurrent, or failed component. Operate within the continuous power rating. Verify ambient temperature is not too high. Operation above continuous power rating and/orproduct environmental rating. The machine duty cycle requires an RMS current exceeding the continuous rating of the controller.Ĭhange the command profile to reduce speed or increase time. The motor is difficult to turn by hand, it must be Disconnect motor power cables form the motor. Verify continuity of motor power cables and connector. Any ideas for some of you would be appreciated.Į74 Drive has exceeded peak current limit. This drive runs a short, simple belt conveyor, have not found a bad bearing or anything.

I opened the panel door and put a fan blowing on the drive stills trips. Last summer we had similar problem but not as bad. I have checked the following and have found nothing. I have a Kinetix 300 drive that keeps giving me a E74 fault.

Put password on factorytalk view studio